Hello Everyone,
It's been a while since I have been involved in the Cheetah community but I am back at it
with the new Cheetah update and a new (to me) MacBook.
In refreshing my knowledge and familiarizing myself with the tools and options, I began
working on a ring design, (attached) but for the life of me, could not get the edges of the
finger hole to bevel. That edge is partially highlighted in red.
I constructed all of this with boolean operations and then reduced it to a single polygon so
is this part of the problem?
My thanks in advance and excited to be back.
It's been a while since I have been involved in the Cheetah community but I am back at it
with the new Cheetah update and a new (to me) MacBook.
In refreshing my knowledge and familiarizing myself with the tools and options, I began
working on a ring design, (attached) but for the life of me, could not get the edges of the
finger hole to bevel. That edge is partially highlighted in red.
I constructed all of this with boolean operations and then reduced it to a single polygon so
is this part of the problem?
My thanks in advance and excited to be back.