New Teddy Bear
I started my Teddy Bear over again again. In an attempt to keep it low poly I tried to avoid using the Ring Cut
for small areas were I needed more geometry (e.g. the nose). I didn't want the hole head to have an extra row of polygons
so I tried to just scalpel in a few extra edges. When I do that I end up with what I call dead ends.
Is this ok or will I run into problems in the long run?
If anyone has any better suggestions on how I can go about making my bear please let me know.
:smile: My Best
Jeanny
I started my Teddy Bear over again again. In an attempt to keep it low poly I tried to avoid using the Ring Cut
for small areas were I needed more geometry (e.g. the nose). I didn't want the hole head to have an extra row of polygons
so I tried to just scalpel in a few extra edges. When I do that I end up with what I call dead ends.
Is this ok or will I run into problems in the long run?
If anyone has any better suggestions on how I can go about making my bear please let me know.
:smile: My Best
Jeanny
Attachments
Last edited: