Add points to already existing Spline

Add points to already existing Spline

I created a spline to use as a path for an object. Is there any way to add additional points in the middle of this spline so that I can make the motion a bit more exact (it needs to follow the terrain I set up and I'm a few points short in the middle)? Thanks and have a great one.
 
Hi,
The insert point tool should fix your problem. Go to Toool/Insert Point. Make sure it is in the editable mode.;).

Greg
 
Last edited:
I was kinda afraid that was the only way. Is there any way to predict where the tool will put the point on my spline? I need a few more points to make it appear as if the vehical is following a rougher terrain
 
Last edited:
Hi,
Not that I know of:(. But you could go into the left for example, and use the create spline tool.

Greg
 
Edit:
Cheetah3d v7 lets you insert points wherever you like in editable splines&meshes: Hoover cursor over edge or spline - click - done.

With kindest regards
Frank
 
Last edited:
Back
Top