UVMapping off the page

UVMapping off the page

I am trying my first attempt at UVMapping and have found that when I unwrap the head of my axe it's off the page. What can I do to either make the page bigger or be able to move the maps up onto the page. I know about the 'select all' and moving them around, but I can't do that if I can't select them. :frown:
 

Attachments

  • Screen shot 2012-04-16 at 5.57.41 AM.png
    Screen shot 2012-04-16 at 5.57.41 AM.png
    88.7 KB · Views: 248
new problem. Did a quick texture and this is the result. Where did I go wrong?? The studs came out alright cause the whole page was the one colour, but when I tried to colour individual things this happened.

There were the steps I took to make the UVMaps.

1. Layout..>UVEditing
2. in line mode marked out the seams
3. >toggle seams
4. >UV unwrap

Then because the head of the axe was off the page.

5. used area select and select all to move the pieces into place.
6. >save UVMap PDF

I know I must be missing a step here somewhere. :rolleyes:

Thank you :smile:
 

Attachments

  • Screen shot 2012-04-16 at 7.04.16 AM.png
    Screen shot 2012-04-16 at 7.04.16 AM.png
    46.4 KB · Views: 238
Did you manage to solve this? If not send me the file and I will show you what to do in the future.

Mike
 
Thank you Mike, give me a day or two and I'll send the file over, your help would be greatly appricated with this.:smile:
I've had to take my computer back to 'default' and am still putting everything back on, but I'm pretty sure I have saved the files onto a disc, just have to find it.:redface:
 
Back
Top