clone problem
Hello!
I would like to clone a part of an object but i have a problem.
If i give a value of the y direction that is bigger then zero, the clones are appeared, but not on the same hight then the original one.
My plan is to rotate the clones on y without y direction, that is why i gave zero. In this case there was't any rotation, clones were placed right on the place of the original polygon.
What is the solution?
thx, Robert
Hello!
I would like to clone a part of an object but i have a problem.
If i give a value of the y direction that is bigger then zero, the clones are appeared, but not on the same hight then the original one.
My plan is to rotate the clones on y without y direction, that is why i gave zero. In this case there was't any rotation, clones were placed right on the place of the original polygon.
What is the solution?
thx, Robert
