Can anyone tell me how to make a single mesh out of two meshes. I am trying to print screenshot 1 but the ball prints INSIDE the box as per screenshot 2. I am trying to print one mesh as per screenshot 3.
Hi and Welcome.
Not 100% sure without pictures - but what you may try is the Boolean-creator to subtract one mesh from another or (better) box+half-of-sphere bridged together:
* If you upload the screenshots 1..3 you have mentioned we would know what the problem is.
* And yes, I know that Mac OSX el Cap screws up screenshots as of lately :frown:
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.