work in progress...

work in progress...

A nearly finished product design job that I thought I share

Once again thanks too Frank for the constant help and tips

Regards
Luke
 

Attachments

  • funky.jpg
    funky.jpg
    32.3 KB · Views: 551
Hi Luke.
That´s pretty. And the colour scheme goes to the girls and the boys;-)
Is the hose made with the sweeptool?

With kindest regards
Frank
 
Hi Luke.
That´s pretty. And the colour scheme goes to the girls and the boys;-)
Is the hose made with the sweeptool?

With kindest regards
Frank


Dear Frank

Thanks...Yes I made a spline and ring then sweep, then copied the spline and used it with a chain modifier and torus ring

sample herewith regards

Luke
 

Attachments

  • tube.zip
    10 KB · Views: 530
Hi Luke.

That´s a neat approach.

I attached a file that comes close with only one chain by ringselecting &extruding the torus with just two additional clicks.

Hope you like it.

With kindest regards
Frank
 

Attachments

  • tubeRevival.jas.zip
    39.3 KB · Views: 495
Hi Luke.

That´s a neat approach.

I attached a file that comes close with only one chain by ringselecting &extruding the torus with just two additional clicks.

Hope you like it.

With kindest regards
Frank


Dear Frank

Your quite right that is a better approach...I guess I was being a bit lazy with the modeling

still the final version here

Regards

Luke
 

Attachments

  • final.jpg
    final.jpg
    35.8 KB · Views: 547
Back
Top