Can't cap this curve

Can't cap this curve

Hi All,

I created this curve in Intaglio and exported it as a combined SVG so its a single path curve. I want to extrude it an put a cap or cover on it. When I try the Polyplane tool it does nothing and when I try the extrude with cover on Front I get only the side extrude of the curve, no cover. Is there anyway I can cap this mofo.

Hi and welcome.
A combined path is not the appropriate tool in this case. To merge different forms use object>path>unite (I think it´s called).
As you can see you have 7 paths in one instead of one whole part the polyplane tool needs.

With kindest regards
Frank

Still can't cap this curve

Hi and Thanks,

Would you be able to post the jas or svg file? I tried to use object>path>unite in Intaglio but it just seemed to close the diameter of the ends of the arrow I created with the arch tool leaving me with four semicircles. I have tried every permutation and combination of the extrude and polyplane creators but nothing seems to give me a surface over the arrow shaped path.

Intaglio



After Unite



And trying Extrude through cheetah



Here is my SVG file

SVG File

Hi.
Starting over:

Have fun.

Cheers
Frank