Scaling question

Scaling question

Hi

I am pretty new to Cheetah and having a few problems with the scale tool. It seems easy enough to grab and scale in one direction at a time, but I can't always grab the centre cube to scale the whole model at once. I seem to end up rotating etc (I know I can do this by keying in figures but this is slower). Is there a key command that I should be using or key I should be holding down?

Thanks
 
If you want to scale uniformly, click (but don't drag) on one cube, and release. Then click anywhere and drag. There's no center cube (unlike Silo).
 
Back
Top