Can a spline be converted to a polygon?
I was going to ask this, but I think I just found a way.
I wanted a red starburst like this:
and was looking for a way to make this as a polygon.
After searching for a way to convert and giving up, I added an extruder, and set the depth to be very minimal and that seemed to do the trick.
Posting here in case anyone else has this question.
I was going to ask this, but I think I just found a way.
I wanted a red starburst like this:
and was looking for a way to make this as a polygon.
After searching for a way to convert and giving up, I added an extruder, and set the depth to be very minimal and that seemed to do the trick.
Posting here in case anyone else has this question.