UI question

UI question

I am just starting to learn Cheetah3d.

I have used Wings3d in the past.

One of the things I did in Wings was to select two edges and connect them by creating a new one by hitting c.

Is there a similar command in Cheetah?

Thanks for any feedback....

Hi,
you can use the skalpel tool to make a arbitarty cut though a polygon from one edge to the other.

Bye,
Martin

Hi.
You can use "create Polygon", if you want just connect them without new polygon use "weld tool".
Maybe I´m wrong with this, but I would mentioned the "c" command in Wings3d will generate new seams not just one n-gon instead of tris.
With kindest regards
Frank